| Uploader: | Mazulabar |
| Date Added: | 5 December 2016 |
| File Size: | 53.10 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 12816 |
| Price: | Free* [*Free Regsitration Required] |
If not, please contact our support team for help. The printer cannot locate the file being sent. Holding the roll of ribbon in your right hand, slide the ribbon onto the ribbon supply shaft with the ribbon unrolling clockwise. Set the clock and clock display. Press Setup and scroll to the bottom of the list. Choose Initializethe second-to-last option on the main menu. When password protect is enabled, the password is required for entering Setting Mode. The printer will do what it can, and then stop.
If you see the same error again, please contact our support team for help.
DuraLabel 7000 Users Guide
Continuous a roll of uninterrupted label stock Black Mark a roll of pre-printed label stock, with a black mark on the backing between labels Die-Cut a roll of pre-cut labels, ready to peel off one by one If this setting was already correct, then click the Calibrate button to have Toro feed some of the label stock through and re-adjust its internal sensors. DuraLabel Toro Software Navigation.
Choose between online chat, request an email, or simply give us a call 70000 speak with a knowledgeable customer support specialist. Top front view 1.
Click on the upper left corner of the spreadsheet to highlight the entire document.
Duralabel Manuals
If you have the original DuraLabel bluethen remove the battery, press and hold curalabel ESC key, and put the battery back in. After the label is cut, the light will change to solid green. Other programs will still work, but only DuraSuite can properly take advantage of Extended Mode printing.
How-to Scan and Print with Echo.
DuraLabel 7000 Quick Start Manual
You can adjust where the printer cuts to make sure the cut is directly centered in the gap by adjusting the Stop Position duralabsl the Stock tab of the Printer Properties. Snap the cutter back in place, and close the print head.
If the label still comes out blank, please contact our support team for help. Click OK to apply the change and close this window, reopen your label program and your label design, and try printing again. These are the advanced controls for your printer. Turn the duralzbel rewind knob on the cartridge euralabel about a quarter of a turn, and try fitting the cartridge into place again. The Darkness can be adjusted from 0 to 19 in increments of 1 by selecting the Options tab in the printer settings.
The print head lever is not properly shut. If prompted to continue, click Continue Anyway. Dudalabel sure the vinyl is under the media sensor below the print head. Check the Supply Loading Turn off the printer using the switch in the back, near the black power cord, and open the printer as if you were going to change all the supplies.
If sensor still does not detect label supply, run Auto Sensing again. Please retain the dkralabel materials in case you need to reship the printer. Make sure the movable sensor mark is at the correct position. Turn off the printer again, wait about five seconds, press and hold the button, and turn the system back on.
The printer may also print out the labels that you were waiting for. Check the Supply Loading First, check 0700 make sure that the supplies are lined up correctly inside the printer. Holding down the left mouse button, drag in the document window the outer corners of the text box until it reaches the desired size.
Comments
Post a Comment